How To Build A Patio Roof Diy

A fireplace on the rooftop might seem unusual to some people but it can create a beautiful space on the roof.

How to build a patio roof diy. Hoist the trusses onto the roof. The new patio cover will be built using Western Red Cedar 4x6 posts 4x6 beams and 2x6 rafters of course you can use Pressure Treated Pine Redwood or any other suitable framing material to build your patio. I then cut off seven inches from the other end at an angle so it would match up to the frames header at the far end.

Get the best of both outdoor worlds with these patio cover plans that show you how to build a roof that is half-closed and half-open. Building a Patio Cover - A Free-Standing Example. Where to Attach a Patio Roof Ledger.

Make sure that the first one is squared to the house 90 degrees. Put a cement footing at each corner of the intended patio roof space and attach anchors to each footing. To complete this step the wall frames of the building must already be level plumb and square.

Wooden seats with flat cushion seats and a small rectangular table can create a perfect seating space. On a one-story house it is often best to attach the ledger for a patio roof just below the houses eaves. I had to cut an angle and a 12 notch at the top ends so the roof of the patio cover would come in below the houses drip edge.

Prepare the joists. The roof will be constructed using Multi-Core Galvalume metal roofing. If attaching a patio roof to a ledger beneath the eaves does not allow for enough headroom you can set the new patio roofs rafters on the walls top plate.

5- DIY Patio Cover with Pergola. One end of this DIY patio cover uses a metal roof and the other end is semi-open with a pergola cover. Once ensured the sheet is of the proper size apply the Vented aluminum tape on the bottom of the width side and Solid Aluminum tape on the top of the width side.